MPA: Control of Smoke Emissions by Vessels in Port

3436

Ship masters and owners of vessels must take all necessary measures to prevent their vessels from emitting excessive soot, ash, or dark smoke from engine exhaust and/or from ancillary shipboard machineries until it’s duration of stay at the port, as per orders from The Maritime and Port Authority of Singapore (MPA).

Fine on failures

MPA takes a serious view on vessels emitting excessive smoke, as it can adversely affect the air quality in the atmosphere. MPA will take stern action against offenders. MPA would also like to draw the attention of ship masters and owners of craft in the port to Regulation 66 of the Maritime and Port Authority of Singapore (Port) Regulations which states that: “No person may cause smoke, soot, ash or grit to be emitted from a vessel in such quantity or density as may, in the opinion of the Authority, be a nuisance.”

Failure to comply with the said regulation is an offence for which offenders can be prosecuted in Court. If convicted, offenders may be fined up to $5,000.

Guideline to prevent dark smoke

1. Smoke includes soot, ash, grit and gritty particles emitted in smoke or steam.

2. For ships that are en route, i.e. with the main engine running, there should be no reason for dark smoke to be emitted from the main engine funnel if the main engine’s fuel, scavenge air and exhaust gas systems and equipment are maintained in good working condition. Regular and proper maintenance of components such as fuel oil heaters, fuel injectors, scavenge air coolers and turbochargers, including frequent washing of exhaust gas economizers (where applicable) go a long way to help reduce the likelihood of dark smoke or excess soot emission from the main engine funnel. Reducing the amount of carbon deposit in the exhaust stream will also help in reducing the amount of dark smoke or soot emission during the initial “kick” when the engine is started.

3. For ships that are at anchorage or at berth, emission of dark smoke can be narrowed down principally to three types of machinery systems, namely generator engines, boilers or inert gas generators.

4. For generator engines, possible causes of dark smoke emission are similar to those mentioned for main engine in paragraph 2, i.e. it is important that the engine’s fuel, scavenge air and exhaust gas systems and equipment are maintained in good working condition. Additionally, it is also helpful to ensure that generators are running at optimal load and are not running under excessively low load or overload conditions.

5. For boilers and inert gas generators, control of the correct air-fuel mixture ratio is important to ensure optimum combustion in the furnace to avoid excessive unburnt fuel,carbon deposits and dark smoke emissions. Regular and proper maintenance of the fuel and air systems and components are essential to ensure proper combustion and reduce likelihood of dark smoke emission. Boiler control settings such as purge timings should be set in accordance with manufacturer’s recommendation for safety reason and also optimum duration of the purging sequence.

6. Aside from good maintenance of the ship’s machinery and systems, ship’s crew should also be vigilant and conduct a frequent check on the funnel emission.

The funnel of a ship integrates all the exhaust trunking running from main engine, generator engines and boiler inside one enclosure. If dark smoke is seen being emitting for prolonged durations from the funnel, the crew should immediately go to the bridge deck and check from which particular exhaust trunk, the dark smoke is spewing, and change over or stop the defective machinery if possible, before carrying out troubleshooting measures.

7. Pollution of the air from emission of dark smoke from ships is a serious concern. With due care and diligence, emission of dark smoke from ships can be minimized and prevented as elaborated in the preceding paragraphs.

Did you subscribe for our daily newsletter?

It’s Free! Click here to Subscribe!

SourceMaritime And Port Authority Of Singapore

1 COMMENT

  1. Dear Mfame Team
    in this article there is a long list of measures to eliminate soot from ships.
    the fact is that with all those measures, there is some soot coming out from stack.
    The Micro-Emulsion technology is able to eliminate soot to zero. It was tested on a Carnival cruise ship. It reduces also NOx, SOx and CO2, by saving fuel. For more information please call me or send a mail.
    Mobil: +972542367030
    Tuvia Berger

Comments are closed.