A 130-meter chemical tanker suffered erosion damage in the grey water tank. Hydrex were contacted by the owner to provide an underwater solution that would allow the vessel to keep her schedule. A team of Hydrex diver/technicians therefore mobilized to Rotterdam to perform on-site repairs, the Hydrex team was contantacted.
About The Damage
- This type of smaller damage is created over time as the result of the recurring impact of for instance water on the exact same spot over and over again.
- On vessels this occurs regularly in the ballast tanks under bell mouths or sounding pipes as was the case with the chemical tanker.
- If the damage is caught before the hull plates are perforated, clad welding can be used to fill up the area.
- This is also a permanent repair that will avoid a condition of class. During the operation in Rotterdam this was no longer an option as a hole had formed in the hull plating.
A Fast, Permanent Solution
Procedure of Effective Solution:
- The divers started the operation by installing a cofferdam on the waterside of the affected plating.
- Next they removed the sounding pipe covering the area on the inside. They could then safely remove a plug which had been installed as a temporary solution.
- The damaged plating was then cleaned and prepared for the operation.
- As agreed with the classification society, the team then cut away an area measuring 300 x 300 mm.
- Next they prepared the edges of the hole for the insert and positioned the new plate. The insert was then welded following the Hydrex class-approved procedure for insert plates, using a full penetration weld.
- An independent inspector carried out ultrasonic testing and the repair was approved by the classification surveyor who was present during the operation.
- The team then reinstalled the sounding pipe and removed the cofferdam.
A small round doubler plate was installed under the pipe to prevent the new insert from eroding again.
Conclusion
We offer class approved permanent repairs for this type of damage. These combine underwater cofferdam installation and inside dry welding. We have a wide range of cofferdams at our disposal as well as certified plating which we can mobilize immediately to any location.
Both parts of such an operation are performed by the same team of in-house trained diver/welders working at the highest quality standards. In most cases normal commercial activities can continue without disruption.
Did you subscribe to our daily newsletter?
It’s Free! Click here to Subscribe!
Source : Hydrex
