Canadian Shipping Route on Detroit River Closed for 30 Hours

1726

The Detroit River’s Canadian shipping channel was closed on June 17, 2019, after the mooring ropes tying a ship carrying 25,000 tons of gravel to shore snapped, says an article published in WindsorStar.

What happened?

Three mooring lines holding the 730-foot Algoma Niagara’s bow to a dock in Sandwich Town snapped around 4 a.m., according to Steve Salmons, president and CEO of the Windsor Port Authority.

The river’s current swung the ship’s hull into the channel 90 degrees, while the stern’s mooring lines remained attached to the dock.

Salmons said that the captain did the right protocol by dropping anchor to stop it from swinging out. By the time the two-year-old ship stopped fully, it was already blocking the shipping channel.

Damage and injury reported

A member of the ship’s crew was reportedly injured when the mooring lines broke, Salmons said, but he didn’t know the nature or severity of the injury.

Peter Winkley, spokesman for the Algoma Central Corporation, which owns the ship, would not confirm if a member of the Algoma Niagara’s crew had been injured. He declined to provide a statement about the incident.

Closure of Canadian side channel

The ship’s captain first reported the incident to Transport Canada’s Ontario office in Sarnia, who then notified the Windsor Port Authority, Salmons said.

His organization immediately closed the Canadian side of the shipping channel to prevent collisions, and kept the channel closed for approximately 30 hours.

No other vessel anchored at that time

“It caused minor inconvenience, but no backups,” Salmons said. If another ship had been in the area at the time, it could have collided with the anchored vessel and created a much worse situation.

“We are fortunate across the board.”

Ethane pipeline not damaged

The ship’s anchor dropped near to the Kinder Morgan pipeline that carries ethane below the Detroit River, but the pipeline was not damaged during the incident.

As a precaution, Kinder Morgan “sealed and purged out” the line, Salmons said, but the company told him its monitoring gauges registered no change in pressure. The line, which is buried several metres below the riverbed, suffered no leak, and has resumed transporting ethane.

Salvage operation expected soon

Two tugboats on Tuesday held the ship in place while crews cut the anchor’s chain and lowered it to the riverbed, Salmons said.

The Algoma Central Corporation, the vessel’s owner, will come “as soon as possible” with a salvage operation to remove the anchor and chain.

Did you subscribe to our daily newsletter?

It’s Free! Click here to Subscribe!

Source: WindsorStar